Trigger error flag
Trigger error flag

Subpage of V3 basic flags


Trigger error type flag or isTriggerError flag

  • The isTriggerError flag shows if any trigger error occured, for details use the Trigger error type flag.
  • The Trigger error type flag shows which type of trigger error has been detected by the ECU.
  • The error message will show the problem at least 1.6 seconds.
  • If more then one error has been detected, the latest error message will be shown.
  • Meaning of values:
    • No Tr Error: no trigger error detected.
    • Too many Pr.trig: too many primary triggers detected (secondary trigger can be missing).
    • Less Pr.trig: less primary trigger detected than it should be.
    • Too many Sec.trig: too many secondary trigger detected than it should be.
    • Less many Sec.trig: less secondary trigger detected than it should be.
    • Sec trig pos bad: secondary trigger detected on bad position according to sectrig validation (to disable it just set minimum to zero and maximum to 360. at Secondary trigger settings).
    • Tooth length bad: the tooth width seems to be wrong (only if Advanced filter is enabled).
    • Safe Mode: the ignition and injection are prohibited, because
      • on the ECU calibration dialog the "prohibit configuration" is bad
      • OR configured to iButton and not yet touched it
      • check these settings at ECU calibration