Subpage of MembersPage/VasilisP
- Sibling of MembersPage/VasilisP/EvapOutput
AC => mot55/pin41 => mcp3208/... analog input => fw configured to raise idle
This setup can increase the idle speed once AC clutch kicks in
- good, only a protected mcp3208 analog input is needed for that
So that my idle doesn't drop or stall.
Believe me i have messed around with idle IAC settings probably more than anyone else,and there are occasions where the idle still drops and stalls. So for that reason alone, i would like to make use of this feature which i believe to be very important for my car.
Yes, understood. Makes sense !
2) I would like to have the option for the AC feature from firmware 1.2.38
Protected analog input needed to connect the 12v signal from the air con compressor to be incorporated to the ecu in order to use the settings to control the idle.
Please write everything you can about YOUR (actual) EC10 pinout in the EC10 section on MembersPage/VasilisP/EvapOutput
Analog input verification
With 1kOhm resistor, see the bottom of [VT help]
- mcp3208/ch6 might be without protection (=not suitable for 12V)
- but other mcp3208/ch (0,1 normally without pullup or 2,5 normally with pullup to +5V) might be suitable for easy connection to AC activation
View gauges: analog inputs raw group.
- Perhaps one of the analog inputs already show when AC clutch is activated ?
- if not, measure voltage on mot55/pin41
- => if mot55/pin41 indicates AC, connect to a protected mcp3208 analog input (and configure and document accordingly).
- if not, measure voltage on mot55/pin41