get error : file "vems.hex" is missing.
duplicate from report: http://vems.hu/vemstune/bugreports/reports.php?cmd=view&key=zprqad
Hello Rico_pl,
Upgrade to firmware higher than 1.2.11 requires bootloader upgrade,
please follow the procedures on:
http://vems.hu/vt/help/v3/general/bootloader_upgrade.html
Best regards, Dave
Thanks Dave, as I bought the car with VEMS unit (Escort Cosworth), I have set Trigger to "Lancia_cosworth".
My first error report shows I have trigger signals but RPM is 0 while cranking. Acc. to WIKI I should use firmware 1.2.26+.
Is this correct ? Or should it work also with 1.2.11 ?
I cannot see why RPM stays 0 while cranking. Fuel is injecting.
BR, Rico
Hello Rico,
To assist you in your startup/trigger debug, i would need the following:
- a triggerlog of engine cranking 8-10 seconds no IGN or INJ fuses
- a vemslog of the same sequence
Using these i can get a beter understanding of whats going on.
You can upload these files to the FileArea and link here or fire a sharing report (from VT) and link that. We'll work from there.
Best regards, Dave
Hi Dave,
here the link http://vems.hu/vemstune/sharingcenter/reports.php?cmd=view&key=pmPtyJ
BR Rico
Hello Rico,
I have reviewed your triggerlog and vemslog, this trigger type should work with special trigger type = Normal, Tdc after the trigger is likely to be around 60deg, use a timing light to verify and adjust.
I have attached a corrected config (having these suggested changes) to your sharing report.
Best regards, Dave
Thanks I will test this. But why is RPM =0 ?
I thought it triggers on TDC so 0 degree ?
BR, Rico
Hello Rico,
When using simple trigger with camsync, rpm will show 0 when cam sync is not accepted (or not seen), so without sync it will not show rpm.
With the corrected settings that should hopefully be solved.
Best regards, Dave