Subpage for VemsExecutives
Because of time pressure ( WBO2 , display, ArmEfi design ):
- Marcell Gal is casedesign executive
- Fero (Ferenc Kulin) is vice executive
Prepared
- Because of machine resources, 500 round cases will be manufactured on the week starting at May 30. The plexi cutout actually starts on May26 !. Main issues:
- outer dia should be 52mm or 51.9mm to be safe ?
- total height of the assembled board: 12mm seems to be worstcase (BA56-126GWA display), so 13 .. 15mm internal space should be very safe.
- a few types can be made, eg.:
- 300 with full-round plexi window (harder to get wrong)
- 200 with rectangular plexi window and drill for button. Determine exact positions and sizes! Rectangulare plexi size needed immediately!!!
- any number of rectangular and round plexi frontplates and endplates, in 3 colors: fully transparent, reddish and green-darkgrey-ish color. These are cheaper than the Al case, so not a problem if there is some excess quantity
- everything is ready for the manufacture of cases based on 120x40x2.5mm profile
- somewhat delayed because of main-connector struggle at VemsExecutives/HardwareDesign. However it is likely that EC36 will be used anyway on some boards, like CDI, so manufacturing frontplates wouldn't hurt. Endplates will be needed for everything, that's little risk.
Plan
- more investigation about small dongle "case"
- wait for final decision on connector and placement (responsible is VemsExecutives/HardwareDesign ). Besides the EC36, the SAAB70 is also a candidate, although not sure how it fits, since the SAAB70 is wider than 120mm externally. For the IonSense/CDI board the EC36 seems like a better candidate
Candidates - for future
- Kulin Ferenc (MembersPage/Fero) (40 hrs/month)
- Rob Humphris (? hrs/month)
- Jörgen Karlsson. Good knowledge about the tools and procedures, good sense for the mechanical function of the finished product and cost for the solution. Fair sense of the estetics. But I'm not close to our current manufacturing facility and do not use the same primitive tools (like using Corel draw to make the parts.) as the manufacturing facility we are currently using. (40hrs/month)
nocandidates