low priority:
More than 6 gears displayed in [VemsDisplay], sequential gearbox
Some sequential gearbox have 8 gears, voltage climbing in this order:
- reverse (lowest voltage)
- neutral (0)
- gear 1-6
original "request" from Roland:
- "extend config_ext.gears[] from 6 to 8 entries" (also used for boostcontrol)
- it turned out that implementing that in firmware + VemsTune would NOT be a solution for them (0..7 or 1..8 displayed would be misleading)
- if android Vemsdisplay is used in triggerframe mode (not AIM mode), than it sees mcp3208 analog inputs: would be possible to configure the voltages there, and display 0-6 and some special symbol for R (perhaps 7 or 8 or 9, but note that it is a special case: non-monotonous)
This wish would be considered normal priority (instead of low) had config + vemslog been provided, + voltages of the actual gearbox model documented
30/8-2016
Read / write from android device.
show Km / Liter