This is my wiring right now (27 jan 2008)
Fuses keep blowing up when I crank the engine.
Coils pin 34 and 36 both use the same fuse. Should I give the their own use?
EC36 Pin Signal Name Max Load
EC36-1 Throttle Position Sensor signal
EC36-2 Intake Air Temperature signal
EC36-3
EC36-4
EC36-5 High-Power Ground (GND5)
EC36-6
EC36-7 Injector 1 10A
EC36-8 Injector 3 10A
EC36-9
EC36-10 Coil #7 7A
EC36-11 Coil #4 7A
EC36-12
EC36-13 Secondary Trigger
EC36-14 Coolant Temperature signal
EC36-15 Fuel Pump relay 350mA
EC36-16
EC36-17
EC36-18
EC36-19 Injector 2 10A
EC36-20 Injector 4 10A
EC36-21 High-Power Ground (GND5)
EC36-22 Unassigned
EC36-23 Flyback Rail
EC36-24 Coil #6 7A
EC36-25 Vbatt (Switched with ignition - hot in start and on positions)
EC36-26 Ground (ECU and signal GND, eg. VR-, CLT, IAT)
EC36-27 Primary Trigger
EC36-28 +5V (to sensors)
EC36-29
EC36-30 Drive_11 (misc output) 350mA
EC36-31 Drive_10 (misc output) 350mA
EC36-32 High-Power Ground (GND5)
EC36-33
EC36-34 Coil #2 10A
EC36-35
EC36-36 Coil #3 10A