I will use 2 banks of 4 injectors. So a total of 8 injectors.
My injectors seem to fire ( I tested with a led) but no fuel exits. Maybe no fuel pressure ? Is the fuelpump powered ? How ?
Injectors
Now using pin 7, 8, 19, 20.
Later I will install the other 4 injectors. (on a motorcycle ? impressive)
Firing order: => 1 2 4 3 (not 1 3 4 2)
Using GenBoard/Manual/DigitalOut/Table as help.
EC36pins injector wiring ,and h[0] mask: From bottom to top ^.
cyl 3 pin 7 - (h[0]01 ?)
cyl 4 pin 19 - (h[0]02 ?)
cyl 2 pin 8 -( h[0]04 ?)
cyl 1 pin 20 ([h[0]08 ?)
This wiring is very nice, the "natural" mask sequence can be used and gives the correct order:
h[0]=01 02 04 08 10 20 40 80
Note that alternate=13 is recommended (fire 4 injector-groups, that is first 4 elements of h[0]. But fire all in batch-simultaneously during cranking).
In MT you will see injector outputs (masks in decimal from top to bottom): 1,2,4,8,16,32,64,128
FUELPUMP
'''My fuel pump was running fine, 3 sec when ecu on, and 1 sec after cranking. Now ones it start running it doesn't go off.
While I haven't changed anything.'''