VolksWagen VR6 Turbo
I have a 1994 VW Golf MkIII 2,8 VR6 (AAA engine code).
The goal is 350 Hp
My setup will be:
- t04 turbo
- bone stock engine
- large 600x300x75 intercooler
- 3" pipeing
- VEMS engine magement
- 727 siemens injectors
My vems is:
- 6+2 igniton
- non ps2
- 30v flyback
- 410 kpa MAP
- EGT no
- Knock no
Ignition firing
The VR6 engine is an even-fire engine with 120 degrees between cylinder events. It uses the same firing order as any in-line 6 cylinder engine, 1-5-3-6-2-4.
The ref tooth table is as suggested 0,40,20,0,40,20 (top to bottom).
Trigger settings
Use the "BMW M20" defaults in the primary trigger dialog to get the correct settings. This engine behaves just like any inline 6 cyl.
Still, use a timing light to verify ignition timing before powering the fuel injectors. Do it again once the engine runs to get a 100% correct value for "TDC after the trigger", use Tools -> Ignition lock and rev the engine a bit.
External links :
- http://en.wikipedia.org/wiki/VR6_engine
- The centerline of the cylinders are also offset from the centerline of the crankshaft by 12.5 millimetres (0.49 in). To accommodate the offset cylinder placement and narrow "Vee" design, the connecting rod bearing journals are offset 22° to each other. This also allows the use of a 120° firing interval between cylinders. The firing order is: 1, 5, 3, 6, 2, 4.
Thank's that's usefull information, I am looking forward to the vr6 butterfly control motor support for idle handling.