Using Vemstune 1.3.1 ,VEMS 3.6 (writes on the order receipt) but Vemstune recognise it like v3.3, firmware 1.2.2.
Engine code: S50B32
Specs:
- 6 cylinder in line
- Infinite variable camshaft angle on both intake and exhaust(VANOS)
- displacement (cm3): 3201
- Stock pistons&rods , 3.5mm Cometic Headgasket and ARP hardware
- Coil on plugs and full sequential
- Stock cams
- Precision Turbo 6262turbo
- 3 vr sensors
- Crank 60-2
- Exhaust 6+1
- Intake 6
- Dual Vanos Enabled
Started the engine in stock form, nothing changed, i only attached my ecu adapter socket to the car's original ecu socket.
I wanted , for the start to verify vanos functionality.
I have problems in getting a stable secondary and third trigger, also, secondary and third triggers tries to follow target cam advance maps, but not with very good success. I have manually put cams in max advance and retard position , and took note of them, after that i have made cam target maps.I have attached leds to solenoid outputs, and they are very unstable, even if in close proximity of cam target. I suspect an unstable trigger signals.
I attach two trigger logs, one only cranking and one at idle, a config file, and a log.