Under this Post I will post a list of Units that will be sent in for repairs. Please do complete functionality test on all units.
Send detailed individual cost of each repair to Info at engdahlmotorsport.se
Ask for return address before sending back, I will change adress 2016-08-30.
Please send out the units 2-3 at a time. As soon as they are ready.
RS232 serial communications
Please note that devices with dual WBO2 (and old devices) have NFET on EC18/pin17 (2nd WBO2 heater), not GND as most new devices.
- That means RS232 connection with GND only on EC18/17 (RS232 GND not connected to EC36/26) will fail to communicate, or worse: sometimes communicate, but unreliably. (eg. communicate with engine off, but frequent comm disconnects with engine running).
Unit number: 4130 belongs to Engdahl/RBD
Damaged LM1815. Unknown reason. Also some unsure funktion of some parts. Test everything.
Please change it, or change is to Hall if not possible without board replacement.
Unit number 11658. Belongs to Engdahl
Brand new unit. Burnt Stepper chip due to short in solenoid.
No communication after the chip fried.
Main board replacement authorized.
Unit Number: 8168. Belings to Engdahl
Injector channel/channels grounds on powerup.
Suspected INJ driver chip damage?
Test it and fix whatever is broken.
Main board replacement authorized.
Unit Number: 2365. Belings to Engdahl/RBD
Communication problems. Sometimes it works, sometimes not.
Bootloader corrupt?
If uncertain, change of main board is authorized.
Unit Number: 4706, Unit Belong to Engdahl
CPU failure.
Tested this on my bench, Very strange problems, then I even burnt myself on the CPU. Efter firmware update it died. No comms.
Main board replacement authorized.
Unit Number: 1959 belongs to Engdahl/RBD
- No communication.
- seems to communicate without problem (no CRC error). Check the bench RS232 cable connection, especially RS232 GND to EC36/26 connectivity
- doing bootloader upgrade and more tests
Main board replacement authorized.
Unit Number: 533 belongs to Engdahl
Really old, lost of problems. I think It died on the testbench.
Change main board and replace any missing/broken parts.
Also add LCD. and Change the front to one without holes.