Lada project
BMW electronic throttle resistance: 1.5 Ohm
ETC interface retrofit to an old ECU
Bridgeoutput driver (external).
Analog inputs - please list !
-lambda 4.2
-pr. trigger: Hall
-PPS1,PPS2
-TPS1, TPS2
-shift cut switch
-config switch
-launch/oil pressure (accept 12V)
-IAT,CLT
- Activate launch control, Shift cut, config switch, PPS1, PPS2, TPS1
- please also mention usage (activate launch, ALS, oilpressure sensor analog input, similar)...
- currently 4 analog inputs (3 used for electronic throttle PPS1, PPS2, TPS2), so 1 remains for other use (is that enough ?)we need plus 2 analog inputs ( summa 6 analog inputs )
Outputs - please list
-4 ignition channel for Audi pencil coil.
-4 injector channel
-throttle body motor
-warning LED
-programabble LED (shift light)
-fuel pump relay
Anything special ? - please take note
- do you need 2nd RS232 RX or TX (for BT => android or AIM => CAN => dash)