Sub-page for questions for MembersPage/SteenAndersen
Questions
I downloaded and compiled the new release [release 1.0.11 since 2004-11-24] from GenBoard/UnderDevelopment/FirmwareChanges page.
I Can'not get the WBO2 to work right.
How do i turn on WBO2 without issuing mde02 command ? (when engine starts)
If i send mde02 command it starts WBO2, and it works fine, but not the egoC:, on display on LCD stays on 0.00.
A: EGO correction can be disabled in several ways, for cold engine, low RPM, high MAP, etc.. see config.ego_.... variables.
In GenBoard/Manual/Config/WBoxygen it say's to "set \n
config13 = 0x02
nothing happens when i turn on the engine, LCD shows La:?.??. and on lcd page 7, wbo2 is OFF.
It is very likely that your RPM reads 0000 because trigger is not enabled or applied.
I do have RPM readings, and pw, iat, clt, and mat is OK on LCD.
The problem is secondary_trigger=FF. Check GenBoard/UnderDevelopment/FirmwareChanges, especially anything about secondary_trigger (or changes after v8 release). Try secondary_trigger=02
My subpage for questions that i need an answer to. Questions witch i have solved or feel is answered is moved to MembersPage/SteenAndersen/History page