Sub-page for questions for MembersPage/SteenAndersen
Questions
My subpage for questions that i need an answer to. Questions witch i have solved or feel is answered is moved to MembersPage/SteenAndersen/History page
I downloaded and compiled the new release [release 1.0.11 since 2004-11-24] from GenBoard/UnderDevelopment/FirmwareChanges page.
I Can'not get the WBO2 to work right. In GenBoard/Manual/Config/WBoxygen it say's to "set config.config13 bit1=1 to enable WBO2 ", so my \n
config13 = 0x02
is right, also cheked others config.txt to confirm. But nothing happens when i turn on the engine, LCD shows ?.??.
It is very likely that your RPM reads 0000 because trigger is not enabled or applied.
If i send mde02 command it starts WBO2, and it works fine, but not the egoC:, on display on LCD stays on 0.00.
EGO correction can be disabled in several ways, for cold engine, low RPM, high MAP, etc.. see config.ego_.... variables.
How do i turn on WBO2 without issuing a command ? (when board starts)
Also on the LCD, there seems to be some minor errors, on one page (think it was page3) a strange looking character was in one position, not a numeric or alphabetic character.
Also i don't have egt: sensor and would like Vbatt, or Engine status (S=Startup,A=Accelerating,D=Decelerating ...) in page 1 on LCD. I looked in lcd_display.c and found\n
PGM_VOID_P lcd_line_03[] PROGMEM = {
lcd_pw, lcd_space,
#ifdef LCD_IAC_PREFERRED
lcd_iacstr, lcd_iacpos,
#else // display EGT
lcd_egtstr, lcd_egt1,
#endif // LCD_IAC_PREFERRED
lcd_idlerpm, LINEEND2
};
Maybe one could put an option to display Vbat and engine status.
All of the above problems where not present when i had v.8 of firmware uploaded in vems. So it's like new bug's or undocumented features. The lcd_display.c code changed quite a bit. There might be buglets still.