11th January 07
First post to set up member page.
13th January 07
This is the salvaged Rover MEMS case that i have decided to use. The middle section needs the original heat sink bars removing to give a little more working space.
Locating the GenBoard towards the back of the case using 10mm isolating stand offs, thus still allowing for heat sinking of the components and also room for the MAP sensor. The Econoseal plugs will be in the same orientation in the case as they would be on the GenBoard, connecting the two with wire. All bare terminals/ connections will be insulated with resin filled heat shrink.
Q. Hoping to put Flyback Diode in this connecting wire - Econoseal Flyback pin to GenBoard. Please confirm this is an acceptable idea?
Looking to put the serial connection 'D connector' through the case some where, for easy connection to the computer.
This is how the finished ECU should look with the D connector on the bottom or the back. All will eventualy be sealed.
Next update will be on the GenBoard itself