Wheelspeed 2 Input
What with the amazing firmware update 1.2.38 I need to consider wheelspeed 2 for traction control, I think it would be rude not to use it!
Looking at InputTrigger/WheelSpeed it says to use the SCL pin on the processor.
The real question is this
- looking at GenBoard/VerThree/Schematic for GenBoard V3.8, it shows circuitry between JP13 SCL-in and SCL on the processor that was never there on older boards.
- Is this the correct protection circuit for wheelspeed 2?
- This is a sensitive connection so I need to be confident it won't end in smoke, I'm tired of that in the past.
Advice welcome. I'm going to need the traction control with 250hp in a small lightweight car!!