Problems with ignition/display help needed
Engine is Rover V8 running still with carburettors, injection to come when ignition are stable.
Display are mounted at end of Vems case and connected with shield cable.
How do I put pictures in her?
Running car with waist spark two Bosch coils:
-As soon as engine starts display on Vems goes bananas, strange characters and sometimes complete blank.
-Engine running ok in idle and up to approximate 2500 rpm.
-Engine misfires above 2500 rpm.
Running car with old distributor ignition system, coil packs disconnected from +12V:
-no problems with display
-at approximate 4000 rpm. revel counter goes to zero. Revel counter connected to IGBT output with 470 ohm and 220uH as pull up.
-Display shortly flickers down to ie. 1200 rpm when app. 4000 rpm are reached.
-With PC and Vemstune rpm also shortly flickers to zero
Tried to run log of VR trigger with Vemstune, seems as all ok at idle, is it possible to log at high rpm?
Wire to coil packs are shield, reused rover cables, but seems to make no difference if shield are connected at ground in Vems end or not.
All ground connections are made as suggested in instructions.
How should “reference tooth” table look?
045
30
15
or?
___
Ignition coils
After solving trigger errors, fuse can be 10A with out problems
Any suggestion for fuse size for coils?
– 15A is blowing! 20A stand with low rpm, and 2ms charge time.
something is terribly wrong than! 4A used during setup shouldn't blow normally (that means about 7A peak current) and than by replacing with 5A fuse (peak current about 9A). Even with distributer, higher than 7A should never be needed.
Isn't that a CDI coil ?
what type coil is that ?
measure resistance of the coil
also measure inductance if you can
Maybe misconfiguration ? Possibly output collision ?
Check validation and all outputs.
Coils are two Bosch motorsports coil, double fire 2x2 coils with four outputs each.
Each coil have one fuse, that blows!
Coil resistance are 0.5 ohm from common +12V to each side of coil
Coil inductance 3,7 mH according to data sheet
Hardware connection coil A:
cyl. 1-6 on output pin 34
cyl. 8-5 on output pin 36
Hardware connection coil B:
cyl. 4-7 on output pin 24
cyl. 3-2 on output pin 10
Ignition sequence 1-8-4-3-6-5-7-2
In which order should output table be?
My config file is under SoerenMartinSorensenRoverV?8