| [ Start] | [Questions ] | [ Injector] | [Ignition] | [Trigger] | [Display] | [Wbo] | [Config] | [Table] | [Wiring] | [Idle] |
D.14/04-2008,this is a pic of the crank and camsensor signal,that we captured today with a scop ,so this look like its supposed to, but with the current trigger setup in the genboard, there is no rpm activity at all.
d.13/04-2008, I have today tried the trigger setup, and there is none rpm activity at all on the rpm gauge, so it does not know its cranking.I checked the wiring again, to be sure that it´s +, that is connected to the EC36-pin27.
I teied to disabel the cam trigger, to see if that made a diff, but none,
The next part must be to get a scoop on the trigger, to check if a signal is comming trough.
Other suggestions would be great.
link to trigger :
this is the hard part,
This subaru legacy is running the 6/7 trigger setup.
as it seems no one have had this running with a VEMS yet, i hope to have some help setting this up,
I will, then ofcourse ducument it,so it will be pnp for other users.
This is the current setting, copied from Wiki,
have not been tested yet, as i have not had the time yet,
But would also like comments, before actuel test.
Firing order 1-3-2-4
primary_trigger=29
secondary_trigger=59
tooth_wheel=02
trigger_tooth=00
another_trigger_tooth=03
crank_minper=75
tooth_wheel_twidth1=00
tooth_wheel_twidth2=00
cam_sync_r_edge_phase=00
cam_sync_f_edge_phase=00
reset_engphase_after=04
toothrel_normal=01
toothrel_missing=F0