| [ Start] | [Questions ] | [ Injector] | [Ignition] | [Trigger] | [Display] | [Wbo] | [Config] | [Table] | [Wiring] | [Idle] |
The car have been of the road for some time now.
the blacktop 20v engine is going to be bored,and new os gze pistons is being put in,
the will be mounted a Impreza TD04-13G turbo to start with and is going to make around 270-290hp at around 1,3bar,still blowing through the Oe ITB´s
Maybe the car will be made to Euro Drift spec?
NOTE
``Please DON’T delete any given information on your site``
peter jensen
Here is a pic from a trackday of the car, Corolla AE86,
Project subpages (without these this is getting a mess, especially if not organized thematically)
About Me
Old MS user and is going to test VEMS now
I have before run a 300+hp 4agze on a MS,
And a 400hp Impreza on a LinkEcu,
All wiring and mapping done by meself,as i had a company here in Denmark,map the Impreza first,then i went on track,and the engine blow,
then i learned it myself
About the Car Toyota AE 86 20v black top engine
- VehicleFitment/Toyota
- MembersPage/PhatBob - Rob did one of these as my his customer install:
- Megatune
The Raw Engineering fitting kit was a good addition. I have tested the standard 4a-ge distributor with VR trigger hardware with coil trigger.