Lada with 12-2 HALL trigger v3/19879 (oid...)
- HALL-HALL, but primary trigger only (1GT101DC Honeywell HALL sensor)
- ... IGBT ?
- 4 cyl
- RPM filter was enabled
- RPM signal was smoother with RPM filter disabled
Hall sensor supply voltage
[1GT101DC''' (see [http://www.vems.hu/download/sensors/1gt101dc.pdf pdf datasheet], wiring, document actual connector pinout).
- IMPORTANT: measurement shows: apparently no +5V supply for the HALL sensor => BIG problem, find and solve it !
- EC36/26 to HALL GND ?
- EC36/27 to HALL signal (sensor output) ?
- EC36/pin28 to HALL + ? (normally +5V, but also works from +12V, where is it connected ? Maybe some fuse blown ? Or some short due to wire insulation damage ?)
Config
- backup from ECU
- vemslog
Wiring
See MembersPage/SimakWrtsLada/HarnessWiring
- custom PVC harness with 3 colors
- Roland ?
Ignition coils
- Magneti marelli
- 3 wire
Links