4.5L SOHC V8, forged pistons, balanced, sleeved, mustang dizzy.
Having trigger issues with this car.
I seem to be able to get a good RPM signal sometimes, around 220-260, sometimes it looses the signal (I'll see 0 RPM in MT)... but even when I get a good rpm signal (constant RPM reading in MT) I don't get a spark output or at the most a very random spark output from IGN out 00...
This is not auditrigger, so mdd0c is totally useless (eg. [log]. See InputTrigger/TriggerLog
60-2 wheel and sensor fitted from an Electromotive trigger kit. And was setup as specified from Electromotive's manual to have TDC on the 11th tooth BEFORE the missing teeth.
It might also be the crank pulley that is causing interference?? The trigger wheel is 6", while i think the crank pulley is 5.5" and is right up against the trigger wheel.
6mm is more than enough if the crank pulley is lathe shape. If it has bolts, that can cause "ghost" pulses.
Pictures of the said trigger wheel and sensor:
Running Firmware 1.0.73.
Primary trigger settings:
Edge: Rising
Type: Multitooth
All filtering, special trigger types is set to: Disabled
TDC after the trigger (deg): 60
Number of teeth on the wheel: 58
Trigger tooth: 1
Next trigger tooth: 15
Crank min. period (usec): 1760 (7500rpm limit - 1000rpm safety)
Angular width of tooth: 2
Angular width of missing tooth: 6