Bosch IAC:
I quick drawing I made of the flyback for use with the 2 PIN Bosch PWM IAC (spring type). Thanks again to Jorgen for helping me with this!
Here are 2 good printable degree wheels that might help someone get their project going when it comes time to setup their crank trigger.
![[Degree Wheel 1]](http://savetheledges.org/test/AVS/images/tech/CrankDegreeWheel.png){kind=link}
![[Degree Wheel 2]](http://www.vespamaintenance.com/elec/timing/degwheel.jpg){kind=link}
Here a factory VW press on crankshaft 60-2 wheel and sensor:
Part numbers:
For wheel and seal rings/mounting plastic - 030 103 171 L
For sensor - 030 906 433 Q
![[Wheel and sensor]](http://img339.imageshack.us/img339/2812/drehzalgebertv8.jpg){kind=link}
- TerminalProgram
- disconnect megatune
- term @ 9600,8n1 connect (COM1 or whatever)
- Man
- mll - sends LCD content, just to test if we are in "Man" menu
- start log
- mcd - so log contains config
- mct - so log contains tables
- mdd0c
- cranking (4..5 sec)
- stop log
- upload log to internet
- bye (this changes mode to MegaTune binary protocol; a reboot does the same)
Back to MembersPage/Sascha