Audi A4 2.7T VEMS Project
The project is a 1996 Audi A4 2.8 with a 2.7T swap.
Using the stock trigger wheel (60-2) and stock sensors for IAT, CLT, with a VW VR6 throttle body, stock turbos. Running with a V3.3 ECU.
For the life of me I can't seem to get the car to run... using the proper settings for a 60-2 in the trigger setup.
58 teeth, trigger tooth 3, next trigger tooth 20, TDC after the trigger ~65 makes the TDC mark on the crank pulley line up almost perfect.
but trying to start the car, all it does it back fire and kick back. Running 3 two pole coils (from a stock Audi 2.8L V6) directly w/ the VEMS, coil out 0,1 & 2 transversed backwards obviously in MT.
RPM readings are about right I'd say during cranking anywhere from 200-290 RPMs.
Firing order is 1-4-3-6-2-5.
The car will somewhat run when the trigger wheel settings are changed to trigger tooth 3 next trigger tooth 10, but the RPMs are WAYYYY off (at approx 2k RPM VEMS is showing 4-45k RPM), but the car runs (we actually drove it out of the shop like that as it had to leave where it was sitting).
I am thoroughly confused about this. Is not every 60-2 wheel set up the same regardless of what car/motor/size of wheel, etc?
Back to MembersPage/Sascha