I started to solve new firmware problems to ver2. Only few new ifdefs is needed so firmware compiles. I haven't tested these but if someone could confirm my changes so it doesn't break anything else. I made these changes to mt-RC2 packet.
for comm.c \n
uint8_t getMCPdataHIGH(uint8_t i) {
uint16_t t;
uint8_t r = 0;
#ifdef GENBOARDv3 //add this
if(i < 8) {
t = mcp3208_data[i];
if (t != 0xffff)
// r = (uint8_t) t >> 8;
r = t >> 8;
}
#endif // add this
return r;
}
\nuint8_t getMCPdataLOW(uint8_t i) {
uint16_t t;
uint8_t r = 0;
#ifdef GENBOARDv3 //add this
if(i < 8) {
t = mcp3208_data[i];
if (t != 0xffff)
r = (uint8_t) t & 0xFF;
read_mcp3208(i);
}
#endif //add this
return r;
}
for fuel calc.c\n
void fill_all_squirters(uint16_t pw)
{
....
// TODO: check if gcc adds sizeof...
} while(i);
#ifdef GENBOARDv3 //add this
#ifdef INJECTOR_STAGING
// Calculating pulsewidth of secondary injectors
uint16_t pw2;
if(engine.tps >= config.inj_stage2_start_tps &&
engine_kpa8() >= config.inj_stage2_start_map)
pw2 = mult16_16(pw, (uint16_t)(config.inj_stage2_rate) + 256)>>8; // effectively (256 + 256) / 256
else
pw2 = 0;
i=SECONDARY_INJ_CHANNELS_NUM;
while(i)
{
i--;
cli();
inj_port_p->pwm_delay = t;
inj_port_p->pwcalc = pw2;
sei();
inj_port_p++;
// TODO: check if gcc adds sizeof...
}
#endif
// calculate injector bitmask used when firing all injectors simultaneously
i = config.alternate & 0x0f;
mask = injport_map(i);
while(i) {
i--;
mask |= injport_map(i);
}
engine.injector_bitmask = mask;
#endif //add this
}
---
Show me where to get latest working and tested ver2.2 firmware that compiles cleanly.