NBO2
Config taken from here: http://www.vems.hu/manual/html/ch09s07.html but on test bench MT reads (fast changing) random voltage (2-5V).
- The NBO2 input is the 2nd nernst channel that is pin EC18-1, not EC18-13 (not correct in manual)
- Found the cause of the problem(?): There is a squre wave at the ADC7 input, it is coming from OC2 pin (atmega pin 17) thru C62 and R137.
The truth is, noone used nbo2 sensor for 4 years. To start the engine it's not needed. To tune the engine it's not suitable.
- I know, I just want to move on with the project, because I dont know when the wbo2 sensor arrives (I bought one from ebay).
So everyone just sells nbo2 sensor and swaps to wbo2, the only reasonable way. If you can start the engine, don't tune before you have WBO2. It does not worth the risks. You can checkout order via IBAN and pay later.
(note: wbo2 sensor hasn't been sent, as you were hesitating and said hold until you ask owner. Orders must go through webshop, not phone anyway)
- Sorry, but this must be a misunderstanding. I ordered the sensor on ebay before I made the order for the genboard in the webshop.