VEMS v3.3 running 1.0.73 fw
It will be built in using the original wires and sensors.
About the engine:
Primary trigger: missing tooth, 60-2, bosch VR sensor (polarity checked)
Secondary trigger: hall (not used yet)
Knock sensing will be used later
Narrow band o2 (help needed with this)
One coil with distributor
Bosch IAC (pwm drive)
115kPa MAP sensor
No EGT
Fire order: 1-3-4-2
440cc high-Z injectors with high voltage flyback
Config: (please check them)
MembersPage/RufolfFeher/TriggerSetup
MembersPage/RufolfFeher/IdleAirSetup
MembersPage/RufolfFeher/IgnitionSetup
MembersPage/RufolfFeher/InjectionSetup
Future TODO:
Change nbo2 to wbo2
Throw out the distributor, and replace with wasted spark coils or COP
Questions:
--How to set up the NBO2?
Config taken from here: http://www.vems.hu/manual/html/ch09s07.html but on test bench MT reads (fast changing) random voltage (0-5V). It does not matter whether the sensor is connected or not.
When I changed the Setting-Constants to WB in MT, it stuck at 0V.