Members Page/Renault Clio Turbo - VEMS wiki www.vems.hu

MembersPage/RenaultClioTurbo (2006-01-05 17:51:02)

Hello

I would like to ask for Your help in converting my

Renault 1,2 8V turbo clio and
Renault Super 5 1,4 8V turbo

to roll-by-roll injection. What kind of options do you advise about the VEMS that control the turbo engine. I don't need too extra things, only that's necessary. I only want the most necessary things, but those that makes my car operate well and I can set my car the best.

Trigger info

trigger must be identified, VR / HALL ?

crankshaft ?
camshaft ?

Ignition outputs

I should replace my extant system ( factory specification RENIX RE-209), anyone has trigger (crank/cam sensor) and ignition transformer info ?

Ign outputs depend on the ignition transformer / ignition module.

Logic-level or power outputs ? 4 IGBT + 4 logic level allows postponing this decision, and use either type.

Other sensors

For CLT, IAT, KNOCK the standard sensor work.

Idle air

You can choose any type:

no iac (adjusted manually, eg. with a screw)
stepper valve (the 4 stepper outputs are used)
PWM solenoid valve
- ("BMW-type") solenoid valve with mid-tap (2 outputs are used - min 350mA)
solenoid ON/OFF valve

For illustration of the inputs, see

but it makes sense to start from someone's setup (from

MembersPage) and change only the few things (in config and HW) that need change.

To my knowledge

I heard that

MembersPage/Fero will help with the pinout mapping
your technician will wire the engines
MembersPage/Fero will help with the starting, and at least at the start of the tuning