---
07.09.2010
I'm trying to set up camsync on BMW M50 inline-6 engine. The engine starts and revs smooth but it shows trigger errors and tends to foul plug on cyl6. I did some triggerlogs with Vems Tune today. Maybe someone can comment my triggerlogs.
Triggers:
Primary - 60-2, VR
Secondary - 1 tooth, Hall
FW 1.1.81
VT 2010-08-19
---
Config - http://www.vems.hu/files/Reinis%20Andersons/v3.3_n002875-2010.09.03-23.33.48.vemscfg
Triggerlog (.csv and .triggerlog)- http://www.vems.hu/files/Reinis%20Andersons/Camsyncm50.zip
---
Should I try to change secondary trigger polarity? Maybe advance secondary trigger tooth about 3 crankdegrees?\n
ID Prim.trig.msec Delta Ratio Sec.trig.msec Delta Comment 290 2201.648(288) 7.784 1.00 291 2209.304(289) 7.656 0.98 292 2216.652(290) 7.348 0.96 293 2223.620(291) 6.968 0.95 294 2242.756(292) 19.136 2.75 "MISSING TOOTH: 2, cycle=58" 295 2248.740(293) 5.984 0.31 296 2254.828(294) 6.088 1.02 297 2261.068(295) 6.240 1.02 298 2267.704(296) 6.636 1.06 ... ... 345 2597.284(343) 7.528 1.08 346 2604.644(344) 7.360 0.98 347 2612.064(345) 7.420 1.01 348 2619.528(346) 7.464 1.01 349 2626.872(347) 7.344 0.98 350 2633.396(2) 6.524 351 2634.264(348) 0.868 0.12 352 2641.388(349) 7.124 8.21 "MISSING TOOTH: 7, cycle=58" 353 2662.048(350) 20.660 2.90 "MISSING TOOTH: 2, cycle=1" 354 2668.928(351) 6.880 0.33 355 2676.172(352) 7.244 1.05 356 2683.532(353) 7.360 1.02 357 2690.228(354) 6.696 0.91
Screenshots from Trigger Analyze:
---
In this screenshot I changed secondary trigger edge from falling edge to rising edge. Loged it to show Hall polarity and how the secondary trigger tooth is positioned.
Thanks, Reinis.