This audi 5cyl works, but experiences "idle fluctuation problem"
We've created this editable page to be able to help him, summarize the findings, suggestions in a thematically organized way.
- does it rather happen with cold air/warm air ?
- cold engine / warm engine ?
We've experienced that similar idle problems are often caused by VE table. Can be very sensitive in some cases. Because of the wideband measurement and EGO delay it's hard to diagnose properly (the leaning shows up later in the log than the actual problematic loadsite).
In many cases the idle fluctuation was cured when the VE was fixed at the right loadsite.
- Temporarily disabling EGO correction (or even permanently for idle) also worths a try.
- injector size= ??
- req_fuel=
History - Mattias wrote on chat:
- some guy with an Audi 5 cyl posted on [this forum]
- he was having trouble with the engine falling through when letting it down to idle
At that point, fuel should be resumed after overrun, shouldn't it?
Expression grid says ecu pulse width = 0, and so it is.. but the overrun fuelcut settings don't say so
http://ranz.planet.ee/idle2.vemslog
In the log he tries at first with no overrun fuelcut, later with the ones in my screenshots
Things to check...
- too low overrun_fuelresume ?
- or maybe lowmap ?
but overrun_fuelresume=1800rpm (maybe not always ? Possibly not true for at all part of the log ?) and fuel back at 1173rpms
Other strange thigs:
- and mat/tps(fuel) table is strange, also mat/tps(retard) is not too safe for turbo
- and boost target is abouve fuel cut
Log analyse (http://ranz.planet.ee/idle2.vemslog)
Interesting thing after tps pulse (rpm falling) and pw:
- There are 3 tps pulses in the log. After the tps pulse when the rpm is falling the pulse with is not 0 and match with the VT calculations but the 2 other cases in falling rpm the pw is 0 and not match with VT calculations.