| [ Start] | [Questions ] | [ Injector] | [Ignition] | [Trigger] | [Display] | [Wbo] | [Config] | [Tables ] | [Idle] |
60-2 no camsync, 4 cylinder using firmware 1.1.12
- batch injection
- wasted spark ignition
- stock Peugeot (Magneti Marelli?) VR sensor (3 wire)
Trigger timing is as shown in the picture. Running direction is Counter Clockwise (wrt picture), 1st and 4th cylinder are at TDC. BTDC = 120 degrees.
Relevant trigger parameters:
primary_trigger=01
secondary_trigger=02
tooth_wheel=3A
trigger_tooth=0A
another_trigger_tooth=1E
crank_minper=50
tooth_wheel_twidth1=18 (decimal 24, that is 6 degrees)
tooth_wheel_twidth2=48 (decimal 72, that is 18 degrees)
ign_tdcdelay=78
ign_crank_advance=12
ign_out=70
ignchmax=03
h[0]=0F 00 00 00 00 00 00 00
h[2]=00 10 00 10 00 10 00 10
Previous problems to learn from:
I had issues with the triggering of the engine. The engine didn't run properly when set up for 120 degrees (trigger_tooth=0A and ign_tdcdelay=0x78; 10*6 + 120*0.5 = 120 degrees)). Remarkely it did run when setup for 60 degrees.
Although it is not clear what exactly caused the timing problem, after using [ALSfix] my problem was over and the engine started with the correct timing.