| [ Start] | [Questions ] | [ Injector] | [Ignition] | [Trigger] | [Display] | [Wbo] | [Config] | [Tables ] | [Idle] |
Trigger data (firmware 1.0.69)
Primary triggering:
Currently using the stock Peugeot (Magneti Marelli) triggering. It uses a 60-2 flywheel with VR sensor. The first tooth after the missing tooth is at 120 degrees before TDC of cylinder 1.
Config:
primary_trigger=01 # multitooth, rising edge
secondary_trigger=02 # disabled/not available
tooth_wheel=3A # 60-2 = 58 teeth
trigger_tooth=02 # first tooth after missing tooth
another_trigger_tooth=1E # trigger 180 degrees later = 30 teeth later
crank_minper=EA # Others have 50
tooth_wheel_twidth1=02
tooth_wheel_twidth2=06
Secondary trigger:
Currently the engine does not have a secondary trigger. I will therefor run batch injection and wasted spark. After I know the ins and outs of this setup i will use a secondary trigger for sequential injection and coil on plug for better control.
I think a VR sensor is easiest to apply. More about that later.