Here is what I need from the VEMS shop. I have stolen the table from Richard Barrington, thanks Richard. The table has been adaopted for my needs.
| Part | Quantity | Price | Total | Comments |
| Components | ||||
| Genboard v3.2 | 1 | 199.00 | 199.00 | |
| 2.5 bar MAP sensor | 1 | 23.00 | 23.00 | |
| Stepper driver | 1 | 3.00 | 3.00 | Run the factory idle setup |
| FET drivers | 4 | 1.90 | 7.60 | 2 banks of injectors, 1 channel WBO2, 1 spare |
| IGBT ignition drivers | 5 | 3.70 | 18.50 | 4 coils in wasted spark, 1 spare |
| WBO2 sensor | 1 | 57.70 | 57.70 | |
| Case | ||||
| Alubos case with 4 drill holes | 1 | 27.00 | 27.00 | If not p'n'p |
| Alubos EC frontplate transparant | 1 | 9.00 | 9.00 | ditto |
| Alubos endplate transparant | 1 | 8.00 | 8.00 | ditto |
| Alubos gasket | 2 | 2.00 | 4.00 | ditto |
| Clamping plate | 2 | 5.00 | 10.00 | ditto |
| Loom | ||||
| Econoseal 36 PCB | 1 | 11.00 | 11.00 | If not p'n'p |
| Econoseal 36 wire | 1 | 9.00 | 9.00 | Ditto |
| Econoseal 18 PCB | 1 | 7.00 | 7.00 | Ditto |
| Econoseal 18 wire | 1 | 8.00 | 8.00 | Ditto |
| Wideband connector | 1 | 8.70 | 8.70 | |
| Extras | ||||
| VEMS sticker | 1 | 0.00 | 0.00 | Advertising under the hood |
| VEMS ECU badge | 1 | 0.00 | 0.00 | Advertising on either case |
| Serial jack kit | 1 | 1.90 | 1.90 | Looks better in the car |
| DSUB9 male | 1 | 1.00 | 1.00 | PC end of the cable |
| Total (Euro) | 413.20 | |||
Other parts needed:
I need a 36-1 crank trigger wheel and VR (variable reluctance) sensor.
I think this is a 60-2 trigger, but might be a usable piece of kit on the (4.0/4.6?) Rover V8? http://www.disco2.com/tech/v8engine/#fly
- No this does not fit with my flywheel. I have an aftermarked flywheel. I can only see a crank wheel work.