- Need help for setting up 36-1 trigger
Edge = rising
Type = multitooth
Filtering = Disabled
TDC after the trigger (vr sensor) deg =??
Number of teeth on the wheel = 35
36-1
Trigger tooth = 1
Number one tooth after the missing one
Next Trigger tooth = 18
Crank min period usec = 3000 (assuming a 4cyl that is 6000usec for a whole crank rotation, which is 10000 RPM), but set it lower to be sure.
- reset_engphase_after=decimal 216 (which is an arbitrary number for 720 crankdegrees, practical for 36 tooth wheel). The values below are in the same unit:
- Angular width of tooth = 3 (10 degrees)
- Angular width of missing tooth = 6 (20 degrees)
With this non-standard missing-tooth shape, the signal will be bigger aroudn the missing tooth, and R181 (factory-installed on v3.3 ; needs a small and clean tracecut surgery before v3.3) becomes important (min 100k, maybe 180k or higher). See InputTrigger/RunOut
I'd
- measure the signal (record with notebook audio input)
- make a wav-file with slightly even peakier missing-tooth amplitude
- this way check if the setup has the margin for the trigger signal processing.
- Thanks for the advice but the standard Ford trigger wheel(crome) will be ok or???