Hi
Need help to get this “nice” jap trigger working
Car Toyota
Engine blacktop
Cas distributor 4 spots on shaft
- tooth width == 180 crankdegrees ?
Problem:
When setting up ignition to 17 degrees BTDC at 1000 rpm its only 7 degrees at 5-6000 rpm so its sliding almost 10 degrees. I have seen this problem long time ago but due not remember what cores the behave.
- usually tooth width configuration problem
- does validate warn about strange values ?
- number of cylinders, or similar ?
- is RPM smooth (or fluctuating) ?
We have tested spark table at 17 and 27 degrees and it slide near 10 degrees.
Triggerlog 1 17 degrees
Triggerlog 2 27 degrees
Log (Config missing)