VEMS Home Products Documentation Wiki Webstore
WikiHome ProjectPage DocsPage UnderDevelopment MembersPage SiteIndex RecentChanges Preferences
MembersPage/PeterJensenTools (2007-08-07 09:31:46)

Corrado g60 turbo

[Start] [Questions ] [ Injector] [Ignition] [Triger] [Display] [Wbo2] [Config] [Table] [Wiring] [Idle] [Tools]

VW Passat

[Start] [Elektronic throttel]

Audi S2

[Start] [Questions ] [ Injector] [Ignition] [Triger] [Display] [Wbo2] [Config] [Table] [Wiring] [Idle] [Tools]

VEMS build instruktions [1]

The I dear is to connect the vems test board in-between vems and the wire harness plug and play or use for test in the lab.

1: simulate 36-1 trigger

2: simulate 60-2 trigger

3 secondary trigger

4: four egt values fore calibrate temp. Toggle switch

5: led diode on all output

6: build in 2x100 ohm resister for calibrate wbo2 sensor

7: 2 rca connectors for simulate trigger input via laptop pc

8: detect Flyback errors

If you have any comments to the vems tester please leave a note, any suggest are welcome

Regards Peter

vems_test_egt.jpg

vems_test_out.jpg

[Image V3.3 Solder side]

[Image V3.3 prosessor side]