Hi
I am starting building the VEMS board for my Corrado g60 turbo.
Corrado 1989
1800 ccm
Turbo Garret T3 60 trim
Mail: motor at webspeed.dk
http://www.vems.hu/files/PeterJensen/config/config.txt
http://www.vems.hu/files/PeterJensen/tables.txt/tables.txt
http://www.vems.hu/files/PeterJensen/wiring/36-1_diagram_vems.cdr
- Make your wiring with Corel Draw just download the “cdr†file all images are already made
Need help for Wbo2
When I issued the command “Manmde02”, the heater turned ON but it seemed to turn OFF again after one scan. The problem was: 1A supply was too weak
If the supply is too weak:
- GenBoard might reset. The uptime seconds counter (that is seen eg. in MegaTune) resetting to 0 shows this
- or possibly, if the sensor is not heated in a reasonable amount of time, the heating decays to wbo2_fallback for wbo2_retry_t time when the heater PID controls takes another chance. La:??.? should be displayed when the heater does not reach target.
If you want to tweak the settings, check the following config variables:
(copied from global.h, the firsthand source of variables)\n
uint8_t wbo2_limit_maxt; // wbo2, max time spent at abs_limit [262msec] uint8_t wbo2_fallback; // wbo2, fallback V after maxt [1c=10V ff=30V] ... actually this comment is bogus, FF is 100% uint8_t wbo2_retry_t; // wbo2, retry control after [4sec]
Need help for compiling firmware
The released binary from GenBoard/UnderDevelopment/FirmwareChanges has WBO2 enabled. (in my_make MY_CONF += -D WBO2)
I triad to compile like:
1. Make clean
2. sh
3. make all
But no vems.hex fil will be generated
If you insist on compiling:
- provide link to zip of some of your files, eg.
- my_make
- winavr version
- output of avr-gcc -v
- error messages: preferrably not images, but text files using output redirection or copy-paste (click on upper-left corner, edit menu)