Subpage of MembersPage/PeteLeh
132+1 Porsche 944 turbo trigger, no missing teeth anywhere, a variation of InputTrigger/AudiTrigger without cam-HALL inverter:
- primtrig: VR sensor ; 132teeth on flywheel
- note: no pullup resistor inside ECU
- not sure if this was intentional, but should NOT matter normally
- if signal has severe noise eg. from WBO2 heater or other source, harness can be fixed, or primtrig 18k pullup to 5V might help suppress the noise.
- sectrig: VR sensor ; Crank home (1 pin on flywheel 24.5 tooth, ie 66.8 dec BTDC 24.5 x 2.7272 deg, if i remember right)
No cam sensor
Ignition sequence: 1-3-4-2
Configuration error: secondary trigger = "Use as primary" is invalid for this engine (it is valid if primtrig sensor is connected to sectrig input AND no sectrig is used).
- Make sure to configure properly. If uncertain, upload config (or vemslog if it shows something interesting), so we can help review and make recommendations.
See VemsTuneVersion