Cylinder numbering and firing order are confirmed as correct. I would definitely write this down too. Don't expect anyone to review your setup without the basic information.
Fill in these - let's make this clear: you're most likely on your without this information
publish firmware info
- Firmware 1.0.38
- and config (mcd, mct). Config updated here: MembersPage/PeepPaadam/Config
Firing order : 1-3-7-2-6-5-4-8
| cyl | ignch | EC36pin.. |
| 1 | 0 | 35 |
| 2 | 1 | 33 |
| 3 | 2 | 34 |
| 4 | 3 | 36 |
| 5 | 4 | 11 |
| 6 | 5 | 12 |
| 7 | 6 | 24 |
| 8 | 7 | 10 |
Without camsync, some trick is needed to drive COP (eg. ign_dualout).
The reasonable wiring is that ignch1 and 0 drive cylinders 360 crankdegree apart. ignch3 and 2 also, etc... That is:
- ignch0,1 cyl 1,6
- ignch2,3 cyl 3,5
- ignch4,5 cyl 7,4
- ignch6,7 cyl 2,8
Update I made the changes in wiring and configured ign-channels
- h[2]=07 03 04 05 01 06 02 00
- You configured it wrong. It's a bad idea to ask on phone, because the chance you miss something important is incredibly high. Plan in wiki, and ask for confirmation (or correction). For cyl 1,3,7,2 (or 6,5,4,8 for that matter) the outputs to be configured are 01,03,05,07 (N-1 will be fired because of ign_dualout, that is 00,02,04,06), so (remember last one is fired first, in MegaTune top to bottom):
- h[2]=07 05 03 01 07 05 03 01
- Do I need to update the firmware from 1.0.38 to something newer?
- you can try 1.0.53 if no better idea, but first configure 1.0.38 properly, it should work
All outputs are logiclevel (0 IGBT inside ECU). Logiclevel outputs pull to GND (0V) when inactive, so when you measure DC voltage with DVM, from 5V as base, you read -5V
- Wiring is separate, i.e. every ign output is to one coil respectavely, also I wired separate +12v supply and grounds for them.
- Switched +12V to coils, they are fused (two banks, 15 amps each) and grounds from the engine. Signal wires come separately from VEMS to each COP.
Car runs ONLY on primary trigger which is stock 100-1 tooth wheel on the flywheel and I don't have cam sync. I fire COPs sequentially and car starts ok every time, but some cylinders don't work on low (below 1500) rpms.
I tried to fire COPs in pairs, as wasted spark, but it did not make any difference.
Note that I fired BMW m50 engine COPs also sequentially by using just stock 60-2 trigger wheel, same low-rpm problem.
The engine runs, but high dwell (3 .. 3.5 msec ?) was needed.
- Im worried about the little voltage (almost none) from VEMS.
- what outputs ?
- what conditions ?
- what's connected ?
- measured how ?
A: I measured all logic level ign outputs and nothing was connected at that time. Used DVM in usual DC mode and it read 1 volt on ign. event. As Marcell said, it's ok.