I reconfigured ignition outputs to wasted spark because I didnt get any voltage when I configured COPs as sequential. It is not clear how it was wired / configured in the 2 cases.
Cylinder numbering and firing order are confirmed as correct. I would definitely write this down too. Don't expect anyone to review your setup without the basic information.
Wiring is separate, i.e. every ign output is to one coil respectavely, also I wired separate +12v supply and grounds for them.
- EXACTLY HOW ? Without camsync, some trick is needed to drive COP (eg. ign_dualout).
The engine runs, but high dwell (3 .. 3.5 msec ?) was needed.
- Im worried about the little voltage (almost none) from VEMS.
- what outputs ?
- what conditions ?
- what's connected ?
- measured how ?