I have a new NTK L1H1 WB02 Sensor, is it possible to use this instead of the Bosch LSU4.2 sensor?
It seems the controller sold at wbo2.com has a jumper to change a resistor, but that only effects the HW RCal method. That's why we don't use NTK with round, but the software calibration method used in v3.x works without changing any resistor.
Note that the small connector pinout is different (from the big, that is in the manual), and pump_pid_kp and pump_pid_ki values are appr. 1/3 of the Bosch sensor. In decimal, wbo2 pump PID values:
- P=15
- I=23
- D=0
See WideBand