My name is Paal, studying administration and economics in Bergen, Norway.
The goal
Apply a GenBoard/VerThree (V3.3) to my Polizei-golf's new engine.
The car is a VW Golf 2 currently running a G60 (PG) engine without the G60 charger (estimated output above 50 hp, but below 90 hp).
the car:
A fresh built 16v KR engine is the new one going in, which is a fine mixture of different Audi S2/4/6 parts etc.
It has a K24 turbo and WG bolted to a chopped S6 exhaust manifold. The intake is from an Audi S2 shortened to 4cyl with a S2 throttlebody and TPS sensor.
The injectors will be 440cc or 507cc (high impedance) on a shortened S2 fuelrail and a 3,5 bar FPR.
Running a OEM 60-2 wheel and VR sensor retrofitted on the crank housing (transmission side) (see http://www.golf1.info/forum/thread.php?threadid=14109&page=2#post151865)
- What is VAG part number for this part?
- Two parts:
- 030103171L - approx 64,44€ - sealing flange with sealing ring and impulse rotor (60-2 wheel and housing)
- 030906433Q - approx 41,02€ - speed sensor (VR sensor with cable - not only a VR sensor with a plug) \\Paal
the engine:
Engine management setup
Hardware:
GenBoard/VerThree V3.3
Preliminary setup:
Assembled v3.3 controller
- - 1-wire interface: no
- - ignition driver: !not determined yet!
- - Knock and EGT: yes
- - LCD and PS2: yes
- - MAP connection: 400kPa onboard (6/4mm pneumatic)
- - mounting-style: screws
- - PowerFlyback: 30V bidir
- - primary_trigger: VR
- - secondary_trigger: HALL
Any comments/input is greatly appreciated.
After advice from MembersPage/SteinOvePrestmo the idea is to run wasted spark ign using the OEM VAG 60-2 wheel and perhaps a 034-efi coil (http://www.034motorsport.com/product_info.php?products_id=40).
Shopping list
I have just started the process of compiling and deciding the components for this build, and how to solve the wasted spark set up.
Ideally this setup should consist of:
- - Retrofitted OEM 60-2 wheel
- - VAG sensors for AIT, water temp
- 0 280 130 085 is a good choise afaik
- ETKA does not recognize this part number - is it correct? I was planning to use as many of the G60/digifant sensors as possible
- - TPS sensor from Audi S2 (I think I found the pinouts for it on this wiki once upon a time)
- works ok
- I cannot locate the schematics for it but any wiring diagram for s2/4/6 should do I think. Will link to it if I find it. \\Paal
- - No knock sensors
- - WBO2
- - EGT (welded somewhere in the DP)
- I would put it before turbo
- Might be tricky since its a cast iron manifold \\Paal
- - 440cc or 507cc high ohm injectors
- - Idle stabilisation valve from G60 PG (solenoid, VAG part # 037 906 457 D)
Will re-order this page and add more info after I get a look at it tomorrow.