vems 3.7 board vr/vr setup
need changing over to vr/hall
engine BMW m50b25tu
- primary trigger=VR 60-2 crank
- R30=18k (but 10k or 27k should also work). You probably do NOT want to change anything around primtrig, since primtrig=VR already (1k would be too strong anyway)
- secondary trigger=HALL sensor on cam
- Changing to HALL should be simple, see GenBoard/Manual/InputTriggerHardWareSectrigHall
bottom view
https://drive.google.com/open?id=1eMa0XuRHrnh7cIYlCcI1ERID85F0nHxQ
top view
https://drive.google.com/open?id=1HEHAyxgnL-CFirkSctx10CqGjVuHbLED
so i understand that the sj7 which is closed need to be opened
about the other 5 holes i see there is a wire attached at another point on the board redwire on the bottom view
do i just disconnect it ??
thanks