Hello!
I assembled my new board into a motronic box with motronic55 connector.
I think this pinout is ok from Econoseal to Motronic55. I would like to if you check it.
http://www.vems.hu/files/Norbitron/econoseal-motronic.xls
I tried to connect my ECU to the PC but it didnt want to communicate. The vemstune couldn't find the ECU. Should i use a special settings? Or did i take a mistake?
Where i will start the troubleshooting?
Thanks
Norbi
-Meanwhile i found the problem. My serial port is wrong (it doesn't want to communicate anything, i don't know why) so i bought a rs232->usb converter. With that the ECU can connect to my computer.