2pc ECU has been ordered in the following option:
2 x ECU VEMS V3
- LCD connection: yes
- Knock input channels: 0
- ignition driver: 4
- Hi-side PFET outputs: 0
- Flyback: HighZ-only 30V flyback
- ETC BridgeOutput_Interface: 1
- EGT input: 2
- 1-wire interface: no
- mounting-style: flanged case
- MAP connection: 400kPa (5/3mm pneumatic)
- primary_trigger: HALL
- secondary_trigger: HALL
- Service: ASAP
- Special requests: no
- withSDcard: no
ECU numbers: 14116 and 14115
And ordered an ETC bridge controller with defaul settings
I have same problem with both ECU. Followed the instructions from help menu step by step when it calibrated.
TPS1-2,PPS1-2 inputs calibrated
TPS% without ETC controller is on 5%
At first time when i connected the ETC motor to the bridge(ETC DC was 0%) the TPS went up to 100%. I Tried on ETC DC=100% the TPS=0% . Ok i tought i have to swap the ETC motor pins. I did it but when i raise the ETC DC From 0% to 100% The TB is closing not opening.
My measurements:
VBatt=12.19V
ETC DC=0% (in Econoseal10 connector)Between Pin1 and GND = 0V, BTw Pin1 and Pin2= -12.14V, Btw Pin2 to GND=12.15V
ETC DC=100% Btw Pin1 to GND = 12.19V, Btw Pin1 to pin2=0.11V, Btw Pin2 to GND = 12.08V
Maybe a wrong FET inside the Bridge because the Pin 2 voltage doesn't change?