Audi 5cyl
60-2 HALL sensor
5xEGT
Drive by wire throttle body (Bosch part number: 022133062 AG)
Oil pressure
Fuel pressure
Oil temp (What kind of sensor do you recommend for this?) This can be 170C.... I know it's hot but possible...
Bluetooth
Vems V3 will order in the following options:
ECU VEMS V3
- 1-wire interface no
- EGT input no
- ETC BridgeOutput_Interface 1
- Flyback HighZ-only 30V flyback
- Hi-side PFET outputs 0
- ignition driver 6+2
- Knock input channels 1
- LCD connection yes
- MAP connection 700 kPa (6/4 pneumatic)
- mounting-style flanged case
- primary_trigger HALL
- secondary_trigger HALL
- Service slow
- Special requests wiki+ordercomment
- withSDcard no
- LSU 4.9 wbo
- Protected stepper with 100ohm
- RS232 port at the endplate
Analog inputs:
- Ch0: (0-5V without pullup) EC18/14
- Ch1: (0-5V without pullup) EC18/16
- Ch2: (0-5V without pullup) EC18/3
- Ch3: (pulled up) EC18/17
- Ch4: (pulled up) EC18/15
- Ch5: (pulled up) EC18/2
- Ch6: Multiplexer ChannelA EC18/6
- Ch7: Multiplexer ChannelB EC18/12
-ETC bridge controller
-Analog input multiplexer
-5*EGT Amplifier(outside)
I want to connect the Multiplexer inputs in the following options:
ChA1=EGT Amplifier1 (0-5V without pullup)
ChA2=EGT Amp2 (0-5V without pullup)
ChA3=EGT Amp3 (0-5V without pullup)
ChB1=EGT Amp4 (0-5V without pullup)
ChB2=EGT Amp5 (0-5V without pullup)
ChB3=Oil temp (Pulled up)
Ch6=Fuel pressure sensor (0-5V without pullup)
Ch7=Oil pressure sensor (0-5V without pullup)
The other analog inputs:
Ch0:TPS2 (0-5V without pullup) EC18/14
Ch1:PPS1 (0-5V without pullup) EC18/16
Ch2:PPS2 (0-5V without pullup) EC18/3
Ch3: Clutch switch for launch (pulled up) EC18/17
Ch4: Program switch (pulled up) EC18/15
Ch5: ALS switch (pulled up) EC18/2
Ch6: Multiplexer ChannelA EC18/6
Ch7: Multiplexer ChannelB EC18/12
I would like to use the original speed input from Audi dashboard. (white/blue, motronic connector pin50). This is a digital signal from the original dashboard. I have never seen this until working.
What should we do to use this?