We would like to use a VEMS V3 for dataloging and data forwarding via CANBUS system to another Engine Control unit. The ECU is a DTA. ECU (DTA or not), should have most of the sensor data anyway
Some information about the dragster.
Audi V6 12V engine
Borg warner S400 turbo
Methanol fuel
dragautomata gearbox
The plan for VEMS:
6xEGT with outside amplifier with 0-5V signal into Analog input multiplexer.
Turbo speed sensor with a little electronic which can send 0-5V signal to VEMS/Datalogger.
Exhaust Pressure Sensor.
2xWBO LSU 4.9
G-power sensor. 2way. 0-5V
Wheel speed sensor
Oil pressure
Oil temp
Fuel pressure
RPM signal
- Is it possible to use the DTA RPM signal output(non pulled up to 5V or 12V) to get RPM value in VEMS?
- yes, almost certainly, with VEMS HALL type input (primary trigger type=coil type...)
And use the vems for PWM controlled N2O system from MAP/RPM tables
- it is not a dash, or logger, but an ECU. Sounds like that is the OUTPUT stream from DTA, right ? (not sure, but it seems like)
We want to see all of the VEMS ECU's values in the DTA's log.
Is it possible?
- Maybe (sounds like a DTA project), but not feasible.
- note: We cannot guarantee anything about DTA's logs.