Back to MembersPage/NanassyPeter
Pending
- MAT ignition retard
- custom oil temp/pressure gauge with V3.3 and LCD
should check the relevant page, IIRC these are not yet implemented
GenBoard/UnderDevelopment/StagedInjectors
- 5 primary injectors, driven sequentially
- and another 5 staged. (note: 2 free injector drivers on this 5cyl engine, because fuelpump switched from an injector channel as well). Document the flowrate of injectors - the ratio of primary and secondary is very important because it must be configured
We have 10 Audi S3/TT high impedance (14ohm) 420ccm "shorty" injectors.So basically we run the same in the staged group as in the sequential "main" injector group.
- Possibly 5 connected (while the FET and EC36xx pin would be happy to drive 5 injectors, highz or properly configured lowz, but this could abuse the flyback.
- or 2+3 split. This is recommended. It's OK to switch them simultaneously though, like h[0]=xx xx xx xx xx xx xx 60 where 60 (decimal 96) is sum of 20 and 40 (decimal 32 and 64) to switch injF and injG (see GenBoard/Manual/DigitalOut/Table)
Sorry ,this section is totally chinees for me....
Please explain it a bit more.
Is it possible to configure fuel pump out to another "thing",to have all 8 injector FETs? How this works on a V8 engine ,where all 8 injectors have to be driven independently?
Anyway,is there any difference between:
1 inj FET driving 2 injectors
VS.
1 inj FET driving 3 injectors??
What injector behaviour can i expect if i drive 2 injectors from 1 inj FET,this way i do not need staging,all injectors will work all the time.There is NO NEED for lean idle,this is a race project.Im basically looking for options here....
How can i insert the new ALS functions (MembersPage/GaborRacz/NewAlsLaunchAndOthers) in the 1.0.30firmware and Megatune??
I still experience some unwanted EGO behaviour sometimes,the EGO correction just switches off (no correction at all),even tough it would be needed!
Please tell me which MegaTune variable to set and which direction??And what is this all about?