- Wiring complete,sensors working,i can see the gauges in Megatune,but there is no RPM signal yet (can wrong calibration (60-2 instead of 5 window) cause this?)
- primary_trigger=FF (or FE if falling edge is used). The primary_trigger=01 is for multitooth (eg 60-2 missing-tooth) setup
- secondary_trigger=02
- TPS reads 10% after calibration,is this normal?
- of course NOT! increase tps_low
A második ecu ba ezeket kérem:
Trigger:
primary crank 60-2
secondary 1 window hall camsync
és a váltás lehetősége csak primary hallra megoldható???
High voltage flyback (6dioda)
All 8 ignition/injector channels
EGT and Knock
4bar MAP sensor onboard (+1 bar MAP for altitude compensation possible?)
Programmable Shift light output
Output for Voltmeter reading WB datas 10:1AFR = 0Volts,
Warning light output with programmable warning tresholds on all measured datas.