Auditrigger on a inline 5 cylinder Audi engine,but now only with distributer,and 1 coil.
After 16 hours of hard work we tried to start the engine.Everything looked great,we had RPM signal during cranking,we had spark (at the right cylinders),and injectorclicking too.Unfortunately the engine did not fired up,after 4 hours of continous problem searching,we did not found the cause of our sadness.We tried different ignition and fuel settings.I also realised that the car dont really want to pull vacuum under cranking (in the vems,map sensor),tough i can feel it with my hand.(no plumbing,only throttle body).Note that the car was running in the past with dual K-jet without problems.We also checked Compression in the cylinders,and they are good.
- i use these tables
- i use these config
- i also made some mdd0c logs (zipped together),please tell me the resoults
Because of the too much unknown factors ,we will install my known working 5 window camHALL triggered ECU,and try to fire the engine up with that.Any comments appriciated.