Back to MembersPage/NanassyPeter
So finally,after 1 year i decided to install the N75 WGFV,and control it via VEMS.
I know from MiskaPeippos page that i have to drive this with a free injector driver.So this will provide the negative voltage,and i should wire the other pin to ignition positive?
- Injector driver provides switched GND to N75 valve and in stock wiring harness 12V is provided together with injector supply.
- I have no exactly correct values, but you can try with ones I picked from MembersPage/Fero
- Boost conf=105 Sets PWM period to 6 (*8ms), MAP target active and reference position.
- Actuator off below this pressure=130kPa Defines lowest pressure when boostcontol starts to do something (I think AAN had a bit higher nominal pressure than 0.3bar boost achieved with wastegate spring)
- Target offset=0
- choose correct channel (INJFET and proper channel with not i)
- Set boost vs. rpm and boost vs. TPS tables as you like
- Try with following settings
- boost P=45
- boost I=27
- boost D=250
- PID integral limit=255
thanks,peter