Back to MembersPage/NanassyPeter
Audi A4 20VT 1.8 AEM engine
Planning to VEMS it.
- VR 60-2 crank trigger
- missing tooth position ?
- HALL camsync
- position (roughly) ?
- what trigger settings will i need to run totally sequential?
- new branch, 1.0.63 should be best for this.
- tooth_wheel_twidth1=18 (normal tooth width=24)
- normal camsync config,
- h[1]=00 5A 3C 1E .. .. .. ..
- More on config when you have trigger position
IAC
DBW throttle with some idiotic servomotors to control idle (will drop it,and use proper stuff)
4 COPS - negotiation/identification in progress
- Beru (this is a 1996 car,not the latest version!)
- connector, pincount ?
- type, text on the coil?
- What measurments needed to know COP type ?
- resistance (Ohm, and diode mode voltage drop) between inputs, both direction
- logic level (likely) or power level output needed?
- => this determines wiring the COPs?
- dwell ?